Requirements
- Intel Galileo Gen 2 board. Looking for instructions on how to assemble your Gen 1 board for use with the Intel® XDK IoT Edition or the Eclipse* IDE?
- One Micro B to Type A USB cable
- 6 pin Serial to Type A USB cable (FTDI cable # TTL-232R-3V3 is recommended)
- One 7-15V DC power supply
Setup
Plug the DC power supply into the wall and the Intel Galileo board.
Image may be NSFW.
Clik here to view.
Wait for 2 green LEDs to light up.
Image may be NSFW.
Clik here to view.
Connect the micro-USB cable to the Intel® Galileo.
Image may be NSFW.
Clik here to view.
Connect the other end to your computer.
Image may be NSFW.
Clik here to view.
Plug in the 6 pin Serial to USB cable.
Image may be NSFW.
Clik here to view.
Plug the other end into your computer.
Image may be NSFW.
Clik here to view.
To Continue, Choose your Operating System:
Troubleshooting
Resources
- Galileo Arduino Expansion Board User Guide
- Galileo Arduino Expansion Board Product Brief
- Galileo Breakout Board Hardware Release Notes
- Introduction to Yocto Project
To set your board up on a wired network use this guide: Galileo Ethernet Networks
