Intel® Edison Board Getting Started with Bluetooth*

Intel® Edison has built-in Bluetooth*, this document demonstrates how to enable Bluetooth* and pair to a device.

Run the following commands to enable Bluetooth*:

     rfkill unblock bluetooth
     bluetoothctl

bluetoothctl will start BlueZ command line utility, when inside the BlueZ command line utility you will see [bluetooth]# at the beginning of each line.

Register an agent and set it to default:

     agent KeyboardDisplay
     default-agent

Scan for Bluetooth* devices by running scan on. The available Bluetooth devices are displayed.

     scan on

To pair to a Bluetooth* device you need the device ID to run the following command.

     pair <Device ID>

Once the device pairs successfully, connect to the device by running this command: 

     connect <Device ID>

To see more commands type help. To exit BlueZ command line utility type exit. See Figure 1 for a screenshot of the process.

Figure 1- Screenshot of Bluetooth* setup.

Resources

Intel® Edison Bluetooth User Guide

Intel® Edison Developer Resources