Overview
In this guide you’ll setup network access to your Intel® Galileo Board and obtain an IP address.
Requirements
- Intel Galileo Gen 2 with power supply
- Micro B to Type A USB cable
- A 6 pin Serial to Type A USB cable (FTDI cable # TTL-232R-)
- Ethernet cable and router connection
Setup Hardware
1. Power on your Galileo and plug in the Ethernet cable. The ethernet port should have a link light.
2. For Intel Galileo Gen 2 Connect the 6 pin Serial to Type A USB cable (FTDI cable # TTL-232R-)
Image may be NSFW.
Clik here to view.
Figure 1. FTDI 6 pin cable, black wire towards bottom of picture correlates to GND.
3. Open Arduino or alternatively, connect with a terminal program, to your Galileo board
4. Within Arduino click on Tools -> Serial Monitor
Image may be NSFW.
Clik here to view.
Figure 2. Serial monitor screen from within Arduino
5. At the bottom of the Serial Monitor set to Carriage return and 115200 baud rate
6. In the top entry area, place your cursor in so it is blinking and hit enter.
7. You should see a prompt. If the prompt begins with root, proceed to the next step, otherwise type in root and a password if necessary. By default there is no root password.
8. From the root prompt type in ‘ifconfig’ and hit enter.
9. The left column defines the connection type, eth0 is the ethernet connection (see Figure 2)
Image may be NSFW.
Clik here to view.
Figure 3. Look for your eth0 entry, if no inet addr showing use step 9.
10. If you do not see this entry, do the following command:
Enter ‘ifup eth0’
Image may be NSFW.
Clik here to view.
Figure 4. After issuing the ifup eth0 command you should see the network negotiate.
11. Enter in ifconfig again, if you see e look to see if an IP address is showing.
Image may be NSFW.
Clik here to view.
Figure 5. Look for the entry of inet addr: and take note of the IP address that follows.
12. To confirm the connection, you may want to take the IP address and open a web browser of a computer on the same network and enter the IP address into a web browser and hit enter. Alternately a ping test can be used.
Return to the Galileo Support page
Troubleshooting
- Get help through the Galileo Communities Forum